BMW R1200RS / R1250RS Forum Community
replacement BAR ends ?? - Printable Version

+- BMW R1200RS / R1250RS Forum Community (https://rswasserboxer.com/R1200RSforum)
+-- Forum: General Forums (https://rswasserboxer.com/R1200RSforum/forum-7.html)
+--- Forum: Parts & Accessories (https://rswasserboxer.com/R1200RSforum/forum-14.html)
+--- Thread: replacement BAR ends ?? (/thread-1081.html)



replacement BAR ends ?? - Joe - 03-04-2024

Hello,

I was thinking of getting some after-market bar ends, as I have a bit of buzz coming through the handlebars....

But I was warned by my service guy that these OEM ones were in fact "heavy" and anything I was likely to find would be "lighter" thereby NOT solving the problem.

Has anyone swapped theirs out from the OEM set ??
What did you get & from where ??
Are they heavier than OEM ?? 
Did it work to reduce the buzz at you hands ??

Thanks !!
Joe


RE: replacement BAR ends ?? - Lee - 03-05-2024

Here's a review on Hudson Valley bar ends for the RT. I don't know if they have a set for the RS.

https://youtu.be/TXtNivDKQy8

Here's the company https://www.hvmp.com/


RE: replacement BAR ends ?? - Oldrider51 - 03-05-2024

I installed a ser of R&G bar ends and got them from TwistedThrottle.com, p/n RG.BE0033BK for a 2016 RS. I never really noticed any "buzz" or vibration through the bars and as far as weight I didn't weigh them for comparison, but I believe if my memory works that they were a little heavier.


RE: replacement BAR ends ?? - Mark - 03-22-2024

I run Hudson Valley bar ends there much heavier than stock. Hudson Valley bar ends


RE: replacement BAR ends ?? - Lee - 03-23-2024

Here's the Hudson Valley site https://www.hvmp.com/BMW-p/bmw-bar-ends.htm