+- BMW R1200RS / R1250RS Forum Community (https://rswasserboxer.com/R1200RSforum)
+-- Forum: General Forums (https://rswasserboxer.com/R1200RSforum/forum-7.html)
+--- Forum: Servicing & Maintenance (https://rswasserboxer.com/R1200RSforum/forum-15.html)
+---- Forum: Do-It-Yourself (DIY) (https://rswasserboxer.com/R1200RSforum/forum-38.html)
+---- Thread: 12K Service (/thread-174.html)
12K Service - Rotorwrench - 07-02-2019
Hey folks,
I just finished installing a new Air Filter as part of the 12k (Too be honest, nothing wrong with the old one that a little shop air couldn't handle) and when I started putting all of the Tupperware back on I noticed that a majority of the Shouldered Screws had been replaced with non-shouldered screws during assembly in Berlin. I need 8 shouldered screws per side according to the BMW RSD & the parts fiche and I only have 8 total. Has anybody else had the same issue that they've noticed?
Later,
Mike
RE: 12K Service - Grumpy Goat - 07-02-2019
Hmmmm ... I have had my fairings off a few times but can't recall how many of each type I have but 8 shouldered screws per side sounds maybe a tad high ... but like I said I can't remember exactly.
RE: 12K Service - Duccrazydave - 07-03-2019
I had the same experience when checking my air filter. 4 of the screws were non-shouldered. Also noticed that the little clear plastic washer (underneath the shouldered bolt heads) was missing on about half of them. all over the bike.
RE: 12K Service - Grumpy Goat - 07-03-2019
(07-03-2019, 04:54 AM)Duccrazydave Wrote: I had the same experience when checking my air filter. 4 of the screws were non-shouldered. Also noticed that the little clear plastic washer (underneath the shouldered bolt heads) was missing on about half of them. all over the bike.
Same experience here. Not all screws had the clear plastic washers and not all screws were shouldered. On the latter point they don't all need to be shouldered - depends on the location. The question is which ones do? See the attached.
Fairing screws.pdf (Size: 661.25 KB / Downloads: 12)
RE: 12K Service - Lee - 07-03-2019
(07-02-2019, 07:40 PM)Rotorwrench Wrote: Has anybody else had the same issue that they've noticed?
When I changed the air filter the first time I noticed some of mine were in the wrong place.
The shop installed Clearwater lights on our bikes when they were new and figured the Tech got the screws in the wrong place.
I had extras on hand but seems like I was short 1 or 2 to get them all correct.
Both bikes were this way.