+- BMW R1200RS / R1250RS Forum Community (https://rswasserboxer.com/R1200RSforum)
+-- Forum: Noticeboard (https://rswasserboxer.com/R1200RSforum/forum-1.html)
+--- Forum: New Member Introductions (https://rswasserboxer.com/R1200RSforum/forum-3.html)
+--- Thread: Hello everyone (/thread-715.html)
Pages:
1
2
RE: Hello everyone - Becksy - 06-29-2022
(05-13-2022, 08:12 PM)Motorhead1977 Wrote:(05-13-2022, 01:32 AM)Becksy Wrote:I have these on the bike:(05-12-2022, 05:55 PM)Motorhead1977 Wrote: I have a set of bar risers on my RS and they lift the bars just enough for my comfort. I too have some back issues so it's a welcome improvement though at least for me I could get along with the standard bar position if I had to. It wasn't necessary to change any cables.
What bar risers did you use?
https://voigt-mt.de/VMT-Voigt-MT-Freiburg-Handlebar-riser-with-offset-30mm-high-and-21mm-closer-for-BMW-R-1200-RS-LC-K54-2015-2019-kit-bar-mounts-inch-pull-back
Hi Motörhead1977 (props to my iPad for automatically putting the umlaut on the O!)
Just installing same risers, did you need to use a clutch cable extender, it’s very much borderline on my bike, should do it really.
RE: Hello everyone - maxredline - 06-29-2022
Check out this tread
Handlebar options
Most of the regular conservative riser options are not in need of a clutch hose extension but most include a hose re-route that may or maybe not include disconnection and fluid bleed.
If you are looking for a more aggressive change then an extension would be needed.
RE: Hello everyone - Motorhead1977 - 06-30-2022
No, all the original hoses and wiring were used without any issues.