08-02-2025, 07:56 PM
(This post was last modified: 08-02-2025, 07:57 PM by Paughco.
Edit Reason: grammar
)
Goat: Thank you for those videos! I had set up my previous bike, a red 2016 S1000XR, with Clearwater Ericas on the front and a Billy Jr. brake light on the back. Only electric mod to OXCART, my current '22 R1250RS is the Powerlet DIN power socket attached at the left passenger peg strut, with the power wire threaded over the top of the battery case and wired directly to the battery. I don't need to spoil the lines of my RS with Ericas on the front because that LED headlight is plenty bright, but I'd like a bit more flash on the tail/brake light.
Inspired by a post on this forum, plus seeing that sanitary wiring job you did in the videos, I just ordered a Denali brake light module from Denali and a Hex ezCan II from Ted Porter's Beemer Shop. I saw on another YouTube video that the CANsmart controller is made by Hex, so I decided to go with that. Looking forward to the install.
I'm thinking about moving my DIN socket wire from the direct battery connection to the ezCan for that extra bit of coolosity.
Keep the shiny side up and the greasy side down
ATB
Inspired by a post on this forum, plus seeing that sanitary wiring job you did in the videos, I just ordered a Denali brake light module from Denali and a Hex ezCan II from Ted Porter's Beemer Shop. I saw on another YouTube video that the CANsmart controller is made by Hex, so I decided to go with that. Looking forward to the install.
I'm thinking about moving my DIN socket wire from the direct battery connection to the ezCan for that extra bit of coolosity.
Keep the shiny side up and the greasy side down
ATB