01-16-2021, 12:19 PM
(01-16-2021, 12:04 PM)AlanM Wrote: Grumpy,
That picture is the opposite of what I found. The large dia with internal spline was at the rear not at the gearbox end. Plus there was a defined stop when felt the final drive u/joint fitting.
PS.
not relevant to post but I was 40 years in industrial gear and u/joint manufacture, starting as apprentice in 1954 finishing as factory manager.
Alan
Grumpy, Sorry re last bit but have had a Very Large G & T plus a couple of glasses of red to celebrate my Covid vaccine without any issues yesterday so am a bit tippsy or pissed.
AlanM