Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Service Bulletin but not for the RS?
#81
(07-08-2024, 05:57 AM)Grumpy Goat Wrote:
(07-08-2024, 05:23 AM)36654 Wrote: Do you remove the rear hinge pivot or just let the final drive unit swing down?

The shaft can be removed by only letting the FD swing down. No need to remove the FD (unless the rear spline is seized on and the transmission end is loose).

Grumpy,

Since the spring clip isn't (or likely isn't) installed, does the forward end of the shaft slide aft, off of the spline?
I knocked, but the door was open.......
Central PA: 2016 Lupin RS - Keys and no TPMS
Reply
#82
(07-08-2024, 06:37 AM)36654 Wrote: Since the spring clip isn't (or likely isn't) installed, does the forward end of the shaft slide aft, off of the spline?

Yes. That’s why I didn’t bother installing the spring clip after I bought it. The main benefit is that it should hold the shaft in place while you drop the FD, unlike what happened to me the first time I pulled my shaft (as you would see in the video). Knowing that there is no clip I just make sure to hold the shaft in place as I rotate the FD down. If I were to bring the bike to the dealer I’d make sure to tell them to watch out for this potential event.
Regards,
Grumpy Goat
2016 BMW R1200RS
2023 Triumph Tiger 900 Rally Pro
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)