Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Motomate bracket & Nav glare
#3
The 1/8 aluminum sides were square cuts to begin with but I had to trim them down from the rear flange (rigidity and safety) to the first bend and then angle the cut out to the second bend. This makes clearance for the brake and clutch revivor when reaching steering lock. Rubber washers were made up to fill the space on the screws that came with the Motomate bracket and used removable loctite once GPS angle was correct.
Still have not tried it but it has to be better than before.
And no GG I haven't been able to find the correct angle with the stock parts. I must be special lol. I really don't notice it much when sitting on the bike. I hope it works 8P
R&D department
Reply


Messages In This Thread
Motomate bracket & Nav glare - by maxredline - 06-15-2023, 10:41 AM
RE: Motomate bracket & Nav glare - by Grumpy Goat - 06-15-2023, 10:45 AM
RE: Motomate bracket & Nav glare - by maxredline - 06-15-2023, 10:49 AM
RE: Motomate bracket & Nav glare - by Grumpy Goat - 06-15-2023, 02:06 PM
RE: Motomate bracket & Nav glare - by maxredline - 06-15-2023, 10:54 PM
RE: Motomate bracket & Nav glare - by Chris216 - 06-16-2023, 05:35 AM
RE: Motomate bracket & Nav glare - by Lee - 06-16-2023, 07:22 AM
RE: Motomate bracket & Nav glare - by maxredline - 06-23-2023, 09:06 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)