Front footrest pad replacement

[Paughco]

Has anybody out there replaced the rubber footrest pad on their bike? The pad on my left footpeg has a tiny crack in the rubber near the tip; it's not bad, but I'd like to replace it. Maybe both of 'em. Here's the part I'm talking about:



It's part 11 on this diagram. The BMW part number is 71 7 700 912. It's available on the Max BMW Parts fiche, and at EroMoto: https://www.euromotoelectrics.com/produc...cd1kWyhcuJ.

It looks like part 8 goes inside a slot in the footrest pad, and it's secured to the foot peg with two blind rivits, part 9. 

I found this YouTube video where the guy drills out the blind rivits, then replaces them with pop-rivits. https://www.youtube.com/watch?v=eed0tggyDqc. That doesn't look too bad, but I don't have a pop-rivit gun. I've also seen a post, somewhere, where a guy drilled out the rivits and substituted small screws and nuts in place of the blind rivits.

So my questions are: Have you replaced a rubber footrest pad on your bike? If so, did you use the BMW blind rivits? Pop rivits? Threaded fasteners? How'd it go?

Yeah - I may be overthinking this, but that's how I roll. It would be nice if BMW still had those DVD shop manuals.

Thank you
 ATB