Motomate R1250RS Nav Mount Review

[Chris216]

GG, no drilling or tapping required, I thought the same as you when I first saw it. The screen pivot mounts fit inside of the cross tube on the motomate. The screws are just barely tightened to set and maintain the angle. No serious modifications required.

Okay, but how does one get the bracket-ended cross tube over the short nubs of the pivot mounts? Are the brackets slotted? Or ...??


Sent from my iPhone using Tapatalk

GG, you remove the screen, then remove the circlip and pin on the upper arm. Then you remove the lower circlip and push the arms outward unitl they are flush with the pivot. The motomate is placed in position between the two and then the arms are pushed inwards to locate and support the motomate (lower circlips are left off). Upper pins and circlips are replaced and the screen reinstalled. The angle of the motomate is adjusted and the two screws are lightly tightened to hold everything in place.