Motomate R1250RS Nav Mount Review

[Grumpy Goat]

GG, you remove the screen, then remove the circlip and pin on the upper arm. Then you remove the lower circlip and push the arms outward unitl they are flush with the pivot. The motomate is placed in position between the two and then the arms are pushed inwards to locate and support the motomate (lower circlips are left off). Upper pins and circlips are replaced and the screen reinstalled. The angle of the motomate is adjusted and the two screws are lightly tightened to hold everything in place.

Thanks Chris. That makes it much clearer. Looks like a good alternative to the Vortex mount I have, cheaper and probably lighter too. The Vortex is very nicely made and, in my opinion, fits the aesthetic a tad better.


Sent from my iPhone using Tapatalk