11-29-2018, 07:15 AM
(This post was last modified: 12-31-2021, 11:48 AM by Grumpy Goat.)
Quote:Actually I was probably more concerned about the width of the sensor compared to rim width, since I will have to be careful with the Cycle Hill tire removal bar. I fully intend to avoid the entire area and also be careful with the tire clunking the sensor.
Grumpy, When using the tire machine you just need to avoid plunging the tool into the rim at the tpm location. Once the tool is in for the 0n or Off operation you can go right by the tpm location with no worries. Plenty of clearance.