Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
RS handlebar conversion in Bay Area
#18
So I’ve gone from the Helibar risers to the Ilium Works Risers. Still not quite enough reach back towards me, and now I’ve just (almost) finished installing the Wunderlich handlebar conversion kit. WHAT a pain in the ass. I’m not a good mechanic, but the instructions were fairly straightforward and I’m unemployed so yeah. Everything was pretty straightforward until I had to re-route the clutch cable. It didn’t look too hard, so started taking panels off. But Bejeesus, there was a zip tie holding the clutch cable to something, and I couldn’t get to it unless I take the radiator off. Pfuck! With no service manual and just ok skills, four hours later I get that zip tie off and it’s displayed forever on my desk.

But sadly I can’t find anything on the interwebs to show me how to bleed the clutch, and since I lost a bunch of coolant too it has to go to the shop anyway. Bastards!


Sent from my iPhone using Tapatalk
Reply


Messages In This Thread
RE: RS handlebar conversion in Bay Area - by Olgry1 - 01-11-2021, 12:59 PM
RE: RS handlebar conversion in Bay Area - by Lee - 02-01-2021, 01:29 PM
RS handlebar conversion in Bay Area - by Pockomoth - 03-12-2021, 08:07 PM
RE: RS handlebar conversion in Bay Area - by Ray - 11-01-2021, 09:15 PM

Forum Jump:


Users browsing this thread: 4 Guest(s)