Hi all,
Pockermouth,
I have done this on both 1200 and 1250RS and have found that after some hours on the first one, plus skinned knuckles, that this cuts the tierap behind the radiator. No snips or scissors can reach and then cut that I have seen.
A HOT SOLDERING IRON
Very very carefully.
Sorry that I did not notice this thread earlier.
There is the same issue on the R1200RS forum.
Alan
Pockermouth,
I have done this on both 1200 and 1250RS and have found that after some hours on the first one, plus skinned knuckles, that this cuts the tierap behind the radiator. No snips or scissors can reach and then cut that I have seen.
A HOT SOLDERING IRON
Very very carefully.
Sorry that I did not notice this thread earlier.
There is the same issue on the R1200RS forum.
Alan