My mods

[AZGeek]

I take it the Cyclops bulb assembly does not come with instructions pointing to the need to first remove the mounting bracket from the rear of the headlight housing ...?

What about the rubber boot I linked to ... is that what you bought?

Most likely a user error on my part regarding the Cyclops instructions. I don’t remember a specific picture for that part of the instruction but once I figured it out it was very obvious what needed to be done. Again, most likely a problem with the user and not the instructions.

Regarding the rubber dust seals, I hedged by bet and bought these:

https://www.ebay.com/itm/2pc-Universal-R...3d55c40ea0

I cut to the exact diameter needed. I will confirm when I take pics of the install, but I think I used the 75mm diameter portion.