My mods

[AZGeek]

Here are the pics for how I did my installation of the Cyclops 4.8 Platinum LED bulb. Left side (high beam) pictured but the same install was done for the right side (low beam).

https://www.cyclopsadventuresports.com/4..._p_86.html

   

First, remove the OEM halogen H7 bulb and keep the connector well outside of the bulb housing.
   

Then remove the collar from the Cyclops bulb assembly and attach it to the RS housing using the clips (used to secure the OEM halogen bulb):
   

I used a universal rubber dust cap because I wasn't sure of the diameter needed. Turns out it should be 70 mm (i.d.), so you can just get that specific size if you want. Or, you can use what I used and removed the excess material: https://www.ebay.com/itm/2pc-Universal-R...3d55c40ea0

I did a simple cross cut in the center of the rubber dust seal to make an exit point for the wires/connectors coming from the LED bulb.
   

Route both ends of the resistor module through the dust seal, then attach the RS connector (female) to the Cyclops resistor module plug (male) and then the 4-pin cable connector from the Cyclops LED bulb to the other end of the Cyclops resistor module.
   

Last pic is in a separate post below. (Don't know why there is a limit to how may images can be attached to a post, but evidently that number is 5).