01-16-2022, 11:54 AM
(This post was last modified: 01-17-2022, 11:13 AM by Grumpy Goat.)
Here are the spacers (shown on bars).
Bar end plugs, I drilled and tapped them for 8-1.25 mm to work with the stock hardware. I used JB Weld steel filled 24 hour set epoxy to glue them into the bar ends (forgot to get a pic of this step
).
Next, mock up the handle bars to get the best position. With spacers in place tighten the front of the clamps first and then the back. Just snug the bars so you can rotate them. Mark things so you can repeat this position on final assembly.
Bar end plugs, I drilled and tapped them for 8-1.25 mm to work with the stock hardware. I used JB Weld steel filled 24 hour set epoxy to glue them into the bar ends (forgot to get a pic of this step
).Next, mock up the handle bars to get the best position. With spacers in place tighten the front of the clamps first and then the back. Just snug the bars so you can rotate them. Mark things so you can repeat this position on final assembly.