BMW R1200RS / R1250RS Forum Community › General Forums › Servicing & Maintenance › Do-It-Yourself (DIY) v
Denali horn on an RS

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Denali horn on an RS
MHN-RS Offline
Junior Member
**
Posts: 30
Threads: 6
Joined: Nov 2023
Reputation: 17
Location: Virginia, USA
#8
12-02-2023, 01:14 PM
(12-02-2023, 01:11 PM)NormR Wrote: Nice right up WAM_thumbsup Just wondering how you secured the horn to the inner fairing panel?

Same way as in the first post, but without the fender washer -- drilled a 15/64" hole (a hair under 1/4" for a tight fit), then used the Denali-supplied bolt and nut.
Find
Reply


Messages In This Thread
Denali horn on an RS - by MHN-RS - 11-22-2023, 06:15 PM
RE: Denali horn on an RS - by MHN-RS - 11-22-2023, 06:16 PM
RE: Denali horn on an RS - by Grumpy Goat - 11-22-2023, 10:41 PM
UPDATE - Denali horn on an RS - by MHN-RS - 12-01-2023, 11:32 PM
RE: UPDATE - Denali horn on an RS - by NormR - 12-02-2023, 01:11 PM
RE: UPDATE - Denali horn on an RS - by MHN-RS - 12-02-2023, 01:14 PM
RE: Denali horn on an RS - by Motorhead1977 - 12-02-2023, 06:04 AM
RE: Denali horn on an RS - by Grumpy Goat - 12-02-2023, 07:51 AM
RE: Denali horn on an RS - by oldjoe - 01-04-2024, 08:58 PM
RE: Denali horn on an RS - by MHN-RS - 01-04-2024, 09:10 PM
RE: Denali horn on an RS - by oldjoe - 01-04-2024, 09:43 PM

Forum Jump:


Users browsing this thread: 6 Guest(s)