Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Got A Nice Ride In Today
#1
Well managed to get a nice ride in today. About 150 miles in SW Mo. & NW Ar. They just opened the Peel ferry at Bull Shoals lake again on weekends (closed due to corvid). So I got a little cooling lake breeze, it's been running low 90's here. Next time need to remember a hat for on the lake! Tongue Wish I could have got more back ground in the picture, but had a car right behind me.

   
Reply
#2
(06-07-2020, 11:40 AM)Chris216 Wrote: About 150 miles in SW Mo. & NW Ar. They just opened the Peel ferry at Bull Shoals lake

Nice riding in that area.
Lee
Iowa, USA
2022 R1250RS White Sport

Past BMWs: 2016 R1200RS x 2,  2011 K1300S x 2,  2003 K1200RS x 2,  1991 K75S x 2,  1987 K75T x 2, 1984 R100RT
Reply
#3
(06-07-2020, 11:40 AM)Chris216 Wrote: Wish I could have got more back ground in the picture, but had a car right behind me.

Looking toward Arkansas.

   
Lee
Iowa, USA
2022 R1250RS White Sport

Past BMWs: 2016 R1200RS x 2,  2011 K1300S x 2,  2003 K1200RS x 2,  1991 K75S x 2,  1987 K75T x 2, 1984 R100RT
Reply
#4
Yes it is some very nice riding, the roads were exceptionally clean given the storms we had lately. I was lucky and all the traffic seemed to be going the other way.
Reply
#5
Very nice. We were in that neck of the woods in 2018 but not the ferry crossing.
Regards,
Grumpy Goat
2016 BMW R1200RS
2023 Triumph Tiger 900 Rally Pro
Reply
#6
(06-07-2020, 11:40 AM)Chris216 Wrote: Wish I could have got more back ground in the picture, but had a car right behind me.
You got the important part of the view.
The bike's looking great.

Sent from my SM-N950U using Tapatalk
"A good man always knows his limitations...."
Reply
#7
Nice, Chris!
Reply
#8
Thanks guys
Reply
#9
If you make it east, I'll note that route 19 north of Eminence (a Butler gold route) has been repaved with smooth black sticky stuff..., and repaving of route 32 has turned it into a race track (not for me, but for some of the locals) through the long sweepers.
"A good man always knows his limitations...."
Reply
#10
Thanks Ray, might have to take a look at that one day.
Reply


Forum Jump:


Users browsing this thread: 6 Guest(s)