Keep in mind my engine has been out of the bike but I trust me mechanic put it back in correctly. My holes in the parts are lined up exactly to the holes. Both the large hole and the small one exactly in front of the side stand are exactly over the holes. The smallest rear one has a zip tie in it to hold that wire likely for the side stand switch and oxygen sensor wire. In between these two holes there is a 3rd hold that has a small screw or bolt which must control exactly how the plastic sits over the holes and tightly against the metal. On your your bike Wayne I can’t tell if you have this screw/bolt. Also notice your cable for the oxygen sensor has some fraying.
Darrell
2016 R1200RS
2022 R1250RT
2016 R1200RS
2022 R1250RT