Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Hello everyone
#21
(05-13-2022, 08:12 PM)Motorhead1977 Wrote:
(05-13-2022, 01:32 AM)Becksy Wrote:
(05-12-2022, 05:55 PM)Motorhead1977 Wrote: I have a set of bar risers on my RS and they lift the bars just enough for my comfort. I too have some back issues so it's a welcome improvement though at least for me I could get along with the standard bar position if I had to. It wasn't necessary to change any cables.

What bar risers did you use?
I have these on the bike:

https://voigt-mt.de/VMT-Voigt-MT-Freibur...-pull-back

Hi Motörhead1977 (props to my iPad for automatically putting the umlaut on the O!) 
Just installing same risers,  did you need to use a clutch cable extender, it’s very much borderline on my bike, should do it really.
Reply
#22
Check out this tread

Handlebar options

Most of the regular conservative riser options are not in need of a clutch hose extension but most include a hose re-route that may or maybe not include disconnection and fluid bleed.
If you are looking for a more aggressive change then an extension would be needed.
R&D department
Reply
#23
No, all the original hoses and wiring were used without any issues.
Happiness comes not from what you have, but from enjoying all that you do have no matter how much or little that may be.
Be stubborn with your dream but flexible with your path
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)