Hello everyone

[Becksy]

I have a set of bar risers on my RS and they lift the bars just enough for my comfort. I too have some back issues so it's a welcome improvement though at least for me I could get along with the standard bar position if I had to. It wasn't necessary to change any cables.

What bar risers did you use?

I have these on the bike:

https://voigt-mt.de/VMT-Voigt-MT-Freibur...-pull-back

Hi Motörhead1977 (props to my iPad for automatically putting the umlaut on the O!) 
Just installing same risers,  did you need to use a clutch cable extender, it’s very much borderline on my bike, should do it really.

[maxredline]

Check out this tread

Handlebar options

Most of the regular conservative riser options are not in need of a clutch hose extension but most include a hose re-route that may or maybe not include disconnection and fluid bleed.
If you are looking for a more aggressive change then an extension would be needed.

[Motorhead1977]

No, all the original hoses and wiring were used without any issues.